DBG_C_WriteCoRegs

Debug Command 15 - Write Coprocessor Registers Command

Parameters

Pid

= Process ID of debuggee processor
Tid
= Nonzero Thread ID of Coprocessor register set to read
Cmd
= DBG_C_WriteCoRegs
Value
= Coprocessor Type Identifier
Buffer
= Pointer to Coprocessor Register Context Buffer
Len
= Size of Coprocessor Register Context Buffer
Index
= Reserved, must be zero

The coprocessor type identifier is a number that identifies the format of the coprocessor register context buffer. The buffer length must correspond exactly to the requested buffer format.

See DBG_C_ReadCoRegs for the supported coprocessor types, formats, and lengths.

The coprocessor register context buffer format is the same as that defined by the fsave/frestore instructions as executed by the appropriate processor.

Returns

The debuggee thread's coprocessor registers are filled with the values passed via the coprocessor register context buffer, for the thread specified in the Tid field.

If an error occurs while attempting to access the coprocessor context during this command, the DBG_N_CoError notification is returned.

Restrictions

An error is returned if any one of the following occurs:

• The debuggee process is emulating the coprocessor. 
  The specified debuggee thread has not yet attempted to use the coprocessor.
  
  The wrong coprocessor type is used.
  
  Index is not zero.

  The coprocessor may adjust some control register bits, but DosDebug will not return an error if a modification is attempted, nor will it mask the values. Because of internal coprocessor management, this adjustment may be delayed until the thread actually uses the coprocessor again.

  ---

  [Back: DBG_C_ReadCoRegs]
  [Next: DBG_C_ThrdStat]